![]() This manual page was written for the Debian distribution because the original program does not have a. IRISC Trace Viewer (Mellanox ConnectX), mft 4.1.0-26, built on Aug 16 2015, 17:32:24. This manual page documents briefly the itrace command. Itrace: read memory (174712 bytes), each dot denotes 2048 bytes: This option is useful for debugging itrace it dumps the contents of the trace buffer in row format. By default, animation is enabled.ĭumps the trace buffer and exits. Sets the itrace not to animate the propeller in wait mode (-w option). If the cr-space device specified by the -d parameter is one of the I2C devices, -nomap is switched on. By default, itrace accesses the memory directly. Sets the itrace to not access memory directly (via memory mapping) for reading the trace buffer, but to use the adapter memory access Gateway instead. To run itrace via the I2C interface, use this option to specify the following: -d=DEVICE, where the device is an I2C device (such as mtusb-1) The default value is:/dev/mst/mt4099_pci_cr0. Specifies the name of the mst device driver for accessing the cr-space. ![]() Without the -w option, itrace will exit if there have been no new traces in the last 0.5 seconds. Note that seccomp no longer runs (and no PTRACEEVENTSECCOMP will be reported) if the system call is skipped due to PTRACESYSEMU. ![]() This is not the default behavior of itrace. PTRACEEVENTSECCOMP stops (since Linux 4.8) Starting with Linux 4.8, the PTRACEEVENTSECCOMP stop was reordered to occur between syscall-entry-stop and syscall-exit- stop.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |